After flashin (ESP-IDF v5.1) the screen keeps flickering very fast (app is installed), can onyone help?

ESP-ROM:esp32s3-20210327 Build:Mar 27 2021 rst:0x1 (POWERON),boot:0x8 (SPI_FAST_FLASH_BOOT) SPIWP:0xee mode:DOUT, clock div:1 load:0x3fce3818,len:0x16e0 load:0x403c9700,len:0x4 load:0x403c9704,len:0xc00 load:0x403cc700,len:0x2eb0 entry 0x403c9908 I (27) boot: ESP-IDF v5.1 2nd stage bootloader I (27) boot: compile time Aug 7 2023 20:39:29 I (27) boot: Multicore bootloader I (30) boot: chip revision: v0.1 I (34) boot.esp32s3: Boot SPI Speed : 80MHz I (39) boot.esp32s3: SPI Mode : DOUT I (43) boot.esp32s3: SPI Flash Size : 8MB I (48) boot: Enabling RNG early entropy source... I (53) boot: Partition Table: I (57) boot: ## Label Usage Type ST Offset Length I (64) boot: 0 nvs WiFi data 01 02 00009000 00006000 I (72) boot: 1 phy_init RF data 01 01 0000f000 00001000 I (79) boot: 2 factory factory app 00 00 00010000 00400000 I (87) boot: End of partition table I (91) esp_image: segment 0: paddr=00010020 vaddr=3c0f0020 size=13a930h (1288496) map I (347) esp_image: segment 1: paddr=0014a958 vaddr=3fc9ae00 size=04cf0h ( 19696) load I (351) esp_image: segment 2: paddr=0014f650 vaddr=40374000 size=009c8h ( 2504) load I (353) esp_image: segment 3: paddr=00150020 vaddr=42000020 size=ec76ch (968556) map I (547) esp_image: segment 4: paddr=0023c794 vaddr=403749c8 size=16360h ( 90976) load I (578) boot: Loaded app from partition at offset 0x10000 I (578) boot: Disabling RNG early entropy source... I (589) cpu_start: Multicore app I (590) octal_psram: vendor id : 0x0d (AP) I (590) octal_psram: dev id : 0x02 (generation 3) I (593) octal_psram: density : 0x03 (64 Mbit) I (598) octal_psram: good-die : 0x01 (Pass) I (604) octal_psram: Latency : 0x01 (Fixed) I (609) octal_psram: VCC : 0x01 (3V) I (614) octal_psram: SRF : 0x01 (Fast Refresh) I (620) octal_psram: BurstType : 0x01 (Hybrid Wrap) I (626) octal_psram: BurstLen : 0x01 (32 Byte) I (631) octal_psram: Readlatency : 0x02 (10 cycles@Fixed) I (637) octal_psram: DriveStrength: 0x00 (1/1) I (643) esp_psram: Found 8MB PSRAM device I (647) esp_psram: Speed: 40MHz I (767) mmu_psram: Instructions copied and mapped to SPIRAM I (903) mmu_psram: Read only data copied and mapped to SPIRAM I (903) cpu_start: Pro cpu up. I (903) cpu_start: Starting app cpu, entry point is 0x403758b0 0x403758b0: call_start_cpu1 at C:/Espressif/frameworks/esp-idf-v5.1/components/esp_system/port/cpu_start.c:154

I (0) cpu_start: App cpu up. I (1289) esp_psram: SPI SRAM memory test OK I (1297) cpu_start: Pro cpu start user code I (1297) cpu_start: cpu freq: 240000000 Hz I (1297) cpu_start: Application information: I (1301) cpu_start: Project name: indicator_openai I (1306) cpu_start: App version: v5.1 I (1311) cpu_start: Compile time: Aug 7 2023 20:39:19 I (1317) cpu_start: ELF file SHA256: 220daa56bfa5f4d2... I (1323) cpu_start: ESP-IDF: v5.1 I (1328) cpu_start: Min chip rev: v0.0 I (1333) cpu_start: Max chip rev: v0.99 I (1338) cpu_start: Chip rev: v0.1 I (1343) heap_init: Initializing. RAM available for dynamic allocation: I (1350) heap_init: At 3FCA7110 len 00042600 (265 KiB): DRAM I (1356) heap_init: At 3FCE9710 len 00005724 (21 KiB): STACK/DRAM I (1363) heap_init: At 600FE010 len 00001FF0 (7 KiB): RTCRAM I (1370) esp_psram: Adding pool of 5952K of PSRAM memory to heap allocator I (1377) spi_flash: detected chip: winbond I (1382) spi_flash: flash io: dout W (1386) ADC: legacy driver is deprecated, please migrate to esp_adc/adc_oneshot.h I (1394) sleep: Configure to isolate all GPIO pins in sleep state I (1401) sleep: Enable automatic switching of GPIO sleep configuration I (1409) app_start: Starting scheduler on CPU0 I (1414) app_start: Starting scheduler on CPU1 I (1414) main_task: Started on CPU0 I (1424) esp_psram: Reserving pool of 32K of internal memory for DMA/internal allocations I (1432) main_task: Calling app_main() I (1437) :

/ / __ / / | / \ _ \/ \/ \/ / \/ / / /| | / // / / / / / / ( ) / // |/ / //_// //__/_/__// |/_/

Version: v1.0.0 Aug 7 2023 20:39:44

I (1477) i2c_bus: i2c0 bus inited I (1481) bsp boards: detecting board SenseCAP_Indicator I (1487) bsp boards: Detected board: [SenseCAP_Indicator] I (1498) gpio: GPIO[38]| InputEn: 1| OutputEn: 0| OpenDrain: 0| Pullup: 1| Pulldown: 0| Intr:0 I (1539) gpio: GPIO[45]| InputEn: 0| OutputEn: 1| OpenDrain: 0| Pullup: 0| Pulldown: 0| Intr:0 I (1576) gpio: GPIO[41]| InputEn: 0| OutputEn: 1| OpenDrain: 0| Pullup: 0| Pulldown: 0| Intr:0 I (1577) gpio: GPIO[48]| InputEn: 0| OutputEn: 1| OpenDrain: 0| Pullup: 0| Pulldown: 0| Intr:0 I (1988) lvgl_port: Add TP input device to LVGL I (2237) view: data max:90.0, min:13.0, char max:128.5, min:-25.5 I (2388) sensor-model: sensor history data read successful I (2391) sensor-model: encode status:0, len:2 0x2 0xa4 I (2395) pp: pp rom version: e7ae62f I (2397) net80211: net80211 rom version: e7ae62f I (2401) wifi:wifi driver task: 3fcd30a4, prio:23, stack:6656, core=0 I (2411) wifi:wifi firmware version: b2f1f86 I (2412) wifi:wifi certification version: v7.0 I (2414) wifi:config NVS flash: enabled I (2418) wifi:config nano formating: disabled I (2422) wifi:Init data frame dynamic rx buffer num: 32 I (2427) wifi:Init management frame dynamic rx buffer num: 32 I (2432) wifi:Init management short buffer num: 32 I (2437) wifi:Init static tx buffer num: 16 I (2441) wifi:Init tx cache buffer num: 32 I (2444) wifi:Init static tx FG buffer num: 2 I (2448) wifi:Init static rx buffer size: 1600 I (2453) wifi:Init static rx buffer num: 10 I (2456) wifi:Init dynamic rx buffer num: 32

_Originally posted by @kheek in https://github.com/Seeed-Solution/SenseCAP_Indicator_ESP32/discussions/6#discussioncomment-6661809_

Seeed-Solution / SenseCAP_Indicator_ESP32