Sensor data stuck in T = 24 and H=50

[xperateur]

Hello,

first of all I'm new in coding and in IOT stuff, sorry if ii do'nt use the right synthaxe.

I have an issue with this Sketch:

Arduino : 2.1.0 ( windows 10), Board : " Arduino MKR WIFI 1010"

here is the full sketch ( i use the exemple TH02_demo)

include

include "Arduino.h"

include "Wire.h"

include "THSensor_base.h"

define ShowSerial Serial

ifdef AVR

#include <SoftwareSerial.h>
SoftwareSerial SSerial(2, 3); // RX, TX
#define COMSerial Serial
#define ShowSerial Serial
TH02_dev TH02;

endif

ifdef ARDUINO_SAMD_VARIANT_COMPLIANCE

#define COMSerial Serial1
#define ShowSerial SerialUSB
TH02_dev TH02;

endif

ifdef ARDUINO_ARCH_STM32F4

#define COMSerial Serial
#define ShowSerial SerialUSB
TH02_dev TH02;

endif

void setup() { ShowSerial.begin(9600); // start serial for output

ShowSerial.println("****TH02_dev demo by seeed studio****\n");
/* Power up,delay 150ms,until voltage is stable */
delay(150);
/* Reset HP20x_dev */
TH02.begin();
delay(100);

/* Determine TH02_dev is available or not */
ShowSerial.println("TH02_dev is available.\n");

}

void loop() { float temper = TH02.ReadTemperature(); ShowSerial.print("Temperature: "); ShowSerial.print(temper); ShowSerial.println("C\r\n"); //Serial.print("%\t");

float humidity = TH02.ReadHumidity();
ShowSerial.print("Humidity: ");
ShowSerial.print(humidity);
ShowSerial.println("%\r\n");
delay(1000);

}

my issue is : i always have the sames results, humidity = 24% ans Température = 50°C

and i still have there result if i unplug my sensor :/

I have try other code the results are the same.

For plug my sensor i have follow the documentation and connect

black --> GND RED--> 5V white--> SDA YEllow --> SCL

Thank in advance,