search

Seeed-Studio / Wio_Link

Wio_Link 8266
http://seeed-studio.github.io/Wio_Link/
182 stars 64 forks source link

Can't connect #39

Closed samhotchkiss closed 7 years ago

samhotchkiss commented 7 years ago

I have an issue that started a few weeks ago, where I simply cannot connect to the Wio servers through any WiFi network nor can I set debug on the device.

I've tried: • Connecting to multiple networks, once I enter the credentials for the new network, the light just blinks in the "connecting to server" pattern for 10+ minutes. I can see it connected to my WiFi, but it never finishes setting up

• Flashing the firmware. Same results

• Turning on debug on the device. I put it into configure mode, connect to its wifi, then:

wio config --debug on
Setting failure!!
Note:
    1. Ensure your device is Configure Mode.
    2. Change your computer network to Wio's AP.

Any ideas? It worked perfectly for months and was being used on a daily basis before this happened

KillingJacky commented 7 years ago

Hi @samhotchkiss Have you switched your device registration to the new server? Like we mentioned here (also we sent mails) http://www.seeedstudio.com/blog/2016/08/25/attention-wio-old-server-shut-down/?utm_source=mailchimp&utm_medium=edm&utm_campaign=wio_0825