I recently converted my gcon 1 (with samco 1.1 pcb) from ItsyBitsy M0 to ItsyBitsy RP2040.
I successfully completed the assembly phase and installed your firmware.
I tested the gun with G4A-GUI and it seems working properly.
My config is custom because I have just 4 buttons: trigger, left, right and (old) calibration.
No solenoid, no rumble, etc...
When I use "Calibrate Profile 1" the calibration procedure completes correctly but I'm unable to enter it without using the software.
The sequence "Press the C Button/Reload (or hold Trigger + A while no IR points are in sight if hold-to-pause is enabled) to enter pause mode." does nothing, the gun remains in its mode.
What am I doing wrong?
I recently converted my gcon 1 (with samco 1.1 pcb) from ItsyBitsy M0 to ItsyBitsy RP2040. I successfully completed the assembly phase and installed your firmware. I tested the gun with G4A-GUI and it seems working properly. My config is custom because I have just 4 buttons: trigger, left, right and (old) calibration. No solenoid, no rumble, etc...
When I use "Calibrate Profile 1" the calibration procedure completes correctly but I'm unable to enter it without using the software. The sequence "Press the C Button/Reload (or hold Trigger + A while no IR points are in sight if hold-to-pause is enabled) to enter pause mode." does nothing, the gun remains in its mode. What am I doing wrong?