Hi, I recently did a lasercut of this keyboard. However, I noticed that the file is actually saved in the wrong measurements.
Currently, the .dxf file properties are in inches and not in millimeters. When exporting, it will convert to a gigantic cutting area if your software reads the original measurements. I think the file should be resaved in the correct drawing preferences.
Hi, I recently did a lasercut of this keyboard. However, I noticed that the file is actually saved in the wrong measurements. Currently, the .dxf file properties are in inches and not in millimeters. When exporting, it will convert to a gigantic cutting area if your software reads the original measurements. I think the file should be resaved in the correct drawing preferences.