Just downloaded gSender v6.5 from GitHub and installed. Connected to LongMill controller no issues yet. Turned on Lightweight mode switch before loading a gcode file. When turned on gSender acted like I had loaded a gcode file. The load file icon does not show a file (X) loaded but the "Test Run" and "Start Job" icons appear. I selected both and they switch to the "Pause" and "Stop" icons with no movement of the tool and the visualizer is blank. I have previously loaded a file as it shows in the "Previous" window. Also every once in testing it was posting values in the X, Y and Z (not zero) positions even though no file loaded. See pictures below. Picture 1 connecting to controller. Picture 2 after connecting to controller and selecting "Lightweight Mode".
Just downloaded gSender v6.5 from GitHub and installed. Connected to LongMill controller no issues yet. Turned on Lightweight mode switch before loading a gcode file. When turned on gSender acted like I had loaded a gcode file. The load file icon does not show a file (X) loaded but the "Test Run" and "Start Job" icons appear. I selected both and they switch to the "Pause" and "Stop" icons with no movement of the tool and the visualizer is blank. I have previously loaded a file as it shows in the "Previous" window. Also every once in testing it was posting values in the X, Y and Z (not zero) positions even though no file loaded. See pictures below. Picture 1 connecting to controller. Picture 2 after connecting to controller and selecting "Lightweight Mode".