Open gismo2340 opened 3 years ago
41E10PBSWM, 41EPBDWCLM, 41E2PBSWM, 41E10PBSWMZ, 41EPBDWCLMZ, 41E2PBSWMZ
Solid Amber - Mechanism is in Zigbee mode and not connected to a Hub
Flashing Amber - Mechanism is in Zigbee and is currently in pairing mode, is not connected to a Hub
Flashing Green - Mechanism is in Zigbee and is in pairing mode, is already connected to a Hub
Solid Green - Mechanism is in Zigbee and is already connected to a Hub that is currently scanning for other mechanisms/devices
Flashing Red and Green - Mechanism is in BLE and is in pairing mode
To swap from Bluetooth to Zigbee you will need to short press the mechanism 12 times - and allow time for the device to swap modes, this will take roughly 40 seconds. Initially when swapped to Zigbee mode the LED indicator on the mechanism will flash amber indicating it is in pairing mode. If not paired to after roughly 50 seconds this will become solid amber. This amber indicator will remain on until paired with a Hub, the mechanism will function as normal while this indicator is on.
NOTE: Before swapping from Bluetooth/BLE to Zigbee it is strongly recommended that a factory reset be performed on the mechanism before initiating the change.
Hi @gismo2340.
Follow the instructions above and try to add the device again and do an interview on the device and attach (as a file) to this issue.
Finally was able to set device as a homey zig bee device. On testing the device will turn on and off and dim from device and homey app. However when controlling the light from the device push button the homey app device icon is not updating the status.
Yes, that sounds about right, there is basic support for lights in Homey when using the generic zigbee driver. But reporting when using physical buttons is not one of them.
I moved your interview to a file Interview 41EPBDWCLMZ.txt
Will look into trying to add it, no promises though.
Thank you for your help so far.
On Sun, 25 Jul 2021, 1:01 am Marcus Hermansson, @.***> wrote:
Yes, that sounds about right, there is basic support for lights in Homey when using the generic zigbee driver. But reporting when using physical buttons is not one of them.
I moved your interview to a file Interview 41EPBDWCLMZ.txt https://github.com/Signalare/com.se.wiserapp/files/6872626/Interview.41EPBDWCLMZ.txt
Will look into trying to add it, no promises though.
— You are receiving this because you were mentioned. Reply to this email directly, view it on GitHub https://github.com/Signalare/com.se.wiserapp/issues/33#issuecomment-886065201, or unsubscribe https://github.com/notifications/unsubscribe-auth/ANDFY25XUJSDLCNKODF65DDTZLIWDANCNFSM5AZJ6YSA .
I am in australia. I am trying to connect a zigbe wiser dimmer module 41epbdwclmz-vw to homey. I think this unit is identical to wde002910 in other countries. I have tried connecting as a wde002910 and homey zigbee device, both with no luck.