search

SmartArduino / SZDOITWiKi

366 stars 73 forks source link

hardware question #17

Open cla68 opened 5 years ago

cla68 commented 5 years ago

Hello. Sorry, I am not sure if I am posting this issue in the correct place. I have just got my ViVi. After assembling I connected pcb to power supply. For a while I had power and a red led was up (on the power supply device) but I was not able to get if on wifi range. During this period servo motors started to moved randomly. After few minutes (I tried to switch on/off pcb to check if wifi could find ViVi...) red light was off and no signal that pcb is active. I tried to connect to other sockets but pcb seems dead. Any idea about that? thanks in advance

daci1973 commented 5 years ago

Hi same issue. Once firmware is loaded, the servo connected to PWM that are driven by Adafruit library is fine. The two servo connected to GPIO (driven by Servo library) are randomly moving.

Has anyone a solution to this? Thanks

cla68 commented 5 years ago

Hi. Is it possible to get the schematic of 18dof board of ViVi robot?? I have some problems and I would like to try to fix it