search

Snapmaker / Luban

An easy-to-use 3-in-1 software tailor-made for Snapmaker machines.
https://snapmaker.com/snapmaker-luban
GNU Affero General Public License v3.0
444 stars 117 forks source link

Bug: timecalculations wrong for lasercutting/laseretching #1203

Closed 0x49b closed 1 year ago

0x49b commented 3 years ago

🐞 bug report

Affected Version(s)

The issue is caused in Luban 4.0.2

Is this a regression? (optional)

The issues did not happen in prior versions to 4.x.x

To Reproduce

Steps to reproduce the behavior:

  1. Create a design
  2. load into Luban Laser module
  3. generate .nc
  4. see calculated time

Expected behavior The time calculations should be preciser. Calculated time by Luban was 1h 42 min. Effective laser etching took 4h 22min. Screenshot from Luban: time_calculation_luban

🌍 Your Environment

F1nnM commented 2 years ago

I'd like to add that there are also cases, where luban seriously overestimates the time. With fill:dots it calculates about three times as much time as it actually takes, in my cases at least.

tensile23 commented 1 year ago

We have optimized the motion part of the firmware, as well as the time firmware of Luban at the same time. This issue will be closed.