Snapmaker Artisan, latest firmware at the time of writing.
I purchased and installed the 0.8mm nozzle for a print I'm working on, and then proceeded to recalibrate the printer (0.8mm left nozzle, 0.4mm right nozzle). On the XY calibration, it correctly selects and prints a gcode variant of the test for 0.8/0.4mm, but when the material used for the test is set as PETG, the Y calibration result cannot be saved. No error is shown on the screen, it just refuses to save and complete.
With the same setup using the PLA profile, it saves correctly. However, no verification print is offered like it does on 0.4/0.4 (does it not have gcode variants for this test?)
Snapmaker Artisan, latest firmware at the time of writing.
I purchased and installed the 0.8mm nozzle for a print I'm working on, and then proceeded to recalibrate the printer (0.8mm left nozzle, 0.4mm right nozzle). On the XY calibration, it correctly selects and prints a gcode variant of the test for 0.8/0.4mm, but when the material used for the test is set as PETG, the Y calibration result cannot be saved. No error is shown on the screen, it just refuses to save and complete.
With the same setup using the PLA profile, it saves correctly. However, no verification print is offered like it does on 0.4/0.4 (does it not have gcode variants for this test?)