search

Snapmaker / Snapmaker-Artisan-Firmware-Issues

3 stars 0 forks source link

Enclosure LEDs keep switching on #22

Closed Blop32 closed 5 months ago

Blop32 commented 5 months ago

Since the latest Artisan Firmware update the enclosure LEDs can't be switched off permanently anymore. I have for now only tested it with the 10W Laser module attached (if this makes a difference...) How to reproduce: Switch on Artisan, start laser job. Switch off LEDs either via Controller, or via Luban (I am connected via WiFi). The LEDs stay off for around 15seconds and then switch on again automatically. I tried dozen of times to switch them off. They always come back on. When there is no laser job running the LEDs seem to stay off as expected. Luban is at the latest version (4.13) and the Artisan has the latest firmware (2.7.2). I guess its a machine firmware issue and not Luban since it can also be reproduced when Luban is not connected and the LEDs are switched off via the controller. The LEDs remained off before the firmware update. Thanks!

Blop32 commented 5 months ago

Nevermind, it suddenly works again now