allow flow test customization

[sedan-cell]

Is there an existing issue for this feature request?

• [X] I have searched the existing issues

Is your feature request related to a problem?

no

Which printers will be beneficial to this feature?

All

Describe the solution you'd like

similar to the other calibrations allow flow rate to be customized. sometimes pass 2 being only negative is not fitting or someone might want smaller steps if possible

Describe alternatives you've considered

No response

Additional context

No response

[pgifford]

sometimes pass 2 being only negative is not fitting

The value from pass 1 should be such that a negative adjustment is required in pass 2.

I agree that customization would be nice, however. For many filaments I could get by with 1 pass at +/- 3. As it is I often run only pass 1; estimating an in-between value is good enough.

[dewi-ny-je]

I think that for most filaments most printers won't need the first pass, if the second one is performed in 101%-91%.

For example I know that my printer always works in a certain range, so I would like to customise the calibration to have, for example, 10 steps in 0.5% increments, rather than 10 steps in 1% increments which I know I won't need.

As alternative, a third pass with 10 samples in 0.5% steps could be offered, even without the need to offer a customisation.

[sedan-cell]

sometimes pass 2 being only negative is not fitting

The value from pass 1 should be such that a negative adjustment is required in pass 2.

I agree that customization would be nice, however. For many filaments I could get by with 1 pass at +/- 3. As it is I often run only pass 1; estimating an in-between value is good enough.

sure and time can be saved by not printing all the others on pass 1

I think that for most filaments most printers won't need the first pass, if the second one is performed in 101%-91%.

For example I know that my printer always works in a certain range, so I would like to customise the calibration to have, for example, 10 steps in 0.5% increments, rather than 10 steps in 1% increments which I know I won't need.

As alternative, a third pass with 10 samples in 0.5% steps could be offered, even without the need to offer a customisation.

same. i know i usually am within 0 to -3 or -4 so i always have to delete a bunch of squares every time. if i can specify the range it saves time and filament