Open Prutsium opened 3 months ago
I too have noticed the size of the prime tower being very inconsistent. I try to shrink the width to 10mm on the snapmaker J1 and the prime tower goes thin until I slice the model or try to adjust the width again. Then the tower stretches out across the build plate. I am trying to cut down the prime tower size for Idex printing where you don't need as much purge.
Found the issue and its not the slicers fault. Reduce purge volume for color changes.
On Sun, 9 Jun 2024, 02:59 hiltpatr, @.***> wrote:
I too have noticed the size of the prime tower being very inconsistent. I try to shrink the width to 10mm on the snapmaker J1 and the prime tower goes thin until I slice the model or try to adjust the width again. Then the tower stretches out across the build plate. I am trying to cut down the prime tower size for Idex printing where you don't need as much purge.
— Reply to this email directly, view it on GitHub https://github.com/SoftFever/OrcaSlicer/issues/5515#issuecomment-2156250897, or unsubscribe https://github.com/notifications/unsubscribe-auth/AKH2M5ZB2GYLXY2K7RNEQFLZGOSGXAVCNFSM6AAAAABISRNPN6VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDCNJWGI2TAOBZG4 . You are receiving this because you authored the thread.Message ID: @.***>
me to same problem with snapmaker A350
The prime tower is using purge volume settings from single nozzle multi color printing. However this setting should be disabled when using a prime tower with multi tool printing as each tool/filament has a setting for it's own prime volume. Additionally the purge volume menu is hidden with multi tool printing enabled so it can not be adjusted easily.
Hello,
So for my Snapmaker A350 dual extruder should I disable it correct?
Thank you
Is there an existing issue for this problem?
OrcaSlicer Version
2.0.0
Operating System (OS)
Windows
OS Version
Win11
Additional system information
No response
Printer
Vcore4 IDEX
How to reproduce
See attached .3mf
Actual results
When specifying a prime tower of 10mm with a purge volume of 3mm3 it creates a rather large prime tower (see image)![image](https://github.com/SoftFever/OrcaSlicer/assets/42968695/63fa71ca-20ce-4818-8ffc-adb9dd5682b4)
When the 10mm parameter is set to 2 it honors the requested size![image](https://github.com/SoftFever/OrcaSlicer/assets/42968695/05c186c5-d518-4498-b746-bad95148ce77)
Expected results
A prime tower of 10x10mm
Project file & Debug log uploads
VC4-300-IDEX-ORCA-Cubes.zip
Checklist of files to include
Anything else?
No response