In previous versions I could create a new profile and add a 0.25mm Revo extruder.
When I would go to print I'd get a warning that the nozzle size does not match the saved nozzle in the printer, and would then get an option to Confirm, Confirm and Update Printer, and Cancel.
By clicking confirm I was able to continue using the 0.25mm nozzle, as it would push the gcode to the printer anyway and the prints would come out fine.
In 2.1 the dialog is now a message to go to the device page and update the printer to continue, but you can't actually update the device because there is no 0.25 nozzle in the firmware to select.
Actual results
Dialog that does not allow clicking Confirm to proceed.
Expected results
Either revert to the old dialog, or add an option to allow for printing without a match between profile and firmware to restore the previous behavior explicitly, otherwise I can't move to 2.1.
Project file & Debug log uploads
Not needed, this is a config option issue not a profile related bug.
Is there an existing issue for this problem?
OrcaSlicer Version
2.1
Operating System (OS)
Windows
OS Version
Windows 11
Additional system information
Not relevant.
Printer
Bambu X1C
How to reproduce
In previous versions I could create a new profile and add a 0.25mm Revo extruder.
When I would go to print I'd get a warning that the nozzle size does not match the saved nozzle in the printer, and would then get an option to Confirm, Confirm and Update Printer, and Cancel.
By clicking confirm I was able to continue using the 0.25mm nozzle, as it would push the gcode to the printer anyway and the prints would come out fine.
In 2.1 the dialog is now a message to go to the device page and update the printer to continue, but you can't actually update the device because there is no 0.25 nozzle in the firmware to select.
Actual results
Dialog that does not allow clicking Confirm to proceed.
Expected results
Either revert to the old dialog, or add an option to allow for printing without a match between profile and firmware to restore the previous behavior explicitly, otherwise I can't move to 2.1.
Project file & Debug log uploads
Not needed, this is a config option issue not a profile related bug.
Checklist of files to include
Anything else?
None.