place this part on the bed , attached below the wall that is 0.45mm will be missing on the front side of the bed, even when you rotate the model to a different position , works ok in prusa slicer
i have also noticed that the wall width is not the same as the setting in the "line width" they are smaller , yet if a print a 1 wall hollow cube they are correct, but not on the model attached
Is there an existing issue for this problem?
OrcaSlicer Version
2.1.1 & 2.2 dev
Operating System (OS)
Windows
OS Version
windows 64 pro
Additional system information
No response
Printer
Valkyrie HT
How to reproduce
place this part on the bed , attached below the wall that is 0.45mm will be missing on the front side of the bed, even when you rotate the model to a different position , works ok in prusa slicer
Actual results
Expected results
as per the screen shot from prusa slicer above T2.zip
Project file & Debug log uploads
T2.zip
Checklist of files to include
Anything else?
i have also noticed that the wall width is not the same as the setting in the "line width" they are smaller , yet if a print a 1 wall hollow cube they are correct, but not on the model attached