Is your feature request related to a problem? Please describe.
The AnkerMake M5 runs on Marlin 2 firmware, not Marlin (Legacy) firmware, and the machine does not run as well using legacy marlin gcode.
Describe the solution you'd like
I would like to see Marlin 2 firmware supported.
Additional context
The firmware of the M5 was just updated to allow 500mm/s slicing, but legacy marlin gcode is a lot harder on the stepper motors then marlin 2.
Is your feature request related to a problem? Please describe. The AnkerMake M5 runs on Marlin 2 firmware, not Marlin (Legacy) firmware, and the machine does not run as well using legacy marlin gcode.
Describe the solution you'd like I would like to see Marlin 2 firmware supported.
Additional context The firmware of the M5 was just updated to allow 500mm/s slicing, but legacy marlin gcode is a lot harder on the stepper motors then marlin 2.