CPU: Intel i9-14900K (32) @ 5.7000GHz , Intel Device a780, GPU: NVIDIA Geforce RTX 3060 Lite Ha, RAM 32Gig
Printer
RatRig VCore 3.1
How to reproduce
If you open Orcaslicer and setup the IP address for the printer, and then save the changes. Orcaslicer with close on its own, if you try to open it again, it will run for a couple of seconds then it will close on its own again. To go back to working conditions, is to go and disable the network adapter on the computer, open Orcaslicer and delete the IP address for the printe, save changes. Then re-enable the network adapter and everything works fine. But I am not able to connect to the printer directly using Orcaslicer.
Noisyfox
commented
5 days ago
Is there an existing issue for this problem?
OrcaSlicer Version
2.2.0
Operating System (OS)
Linux
OS Version
Linux Mint 21.3 Edge
Additional system information
CPU: Intel i9-14900K (32) @ 5.7000GHz , Intel Device a780, GPU: NVIDIA Geforce RTX 3060 Lite Ha, RAM 32Gig
Printer
RatRig VCore 3.1
How to reproduce
If you open Orcaslicer and setup the IP address for the printer, and then save the changes. Orcaslicer with close on its own, if you try to open it again, it will run for a couple of seconds then it will close on its own again. To go back to working conditions, is to go and disable the network adapter on the computer, open Orcaslicer and delete the IP address for the printe, save changes. Then re-enable the network adapter and everything works fine. But I am not able to connect to the printer directly using Orcaslicer.
Actual results
Nothing to screen shot.
Expected results
I just need some kind of help.
Project file & Debug log uploads
n/a
Checklist of files to include
Anything else?
No response