search

SolDoesTech / HyprV3

V3 of Hyprland install script for arch
176 stars 44 forks source link

Works great, apart from multi monitors #2

Open Script20 opened 1 year ago

Script20 commented 1 year ago

So I have 3 monitors, I have the main one in the middle 27" 1440p 165hz, and 2 to the right and left, both at 24" 1080p

When I want to go to the others I have to move mouse left and and they are not setup correctly, it;s like they are in a line to the left of the monitor but they are either side, can I change the location of the monitors?

So I go left and it goes to the left monitor and right to the right monitor? I know it's with in the hyprland.conf but first time using hyprland not sure what im doing TBH.

Script20 commented 1 year ago

But thank you so much for the effort, I wanted to move to linux for sometime, but not found a DE or WM that I liked and wanted to use enough to put all the time into changing every. you're great thank you so much!

JesseKoldewijn commented 1 year ago

But thank you so much for the effort, I wanted to move to linux for sometime, but not found a DE or WM that I liked and wanted to use enough to put all the time into changing every. you're great thank you so much!

Did you manage to fix your config for your multi monitor setup? If not, please reply back with the command output of the following command:

hyprctl monitors
Script20 commented 1 year ago

But thank you so much for the effort, I wanted to move to linux for sometime, but not found a DE or WM that I liked and wanted to use enough to put all the time into changing every. you're great thank you so much!

Did you manage to fix your config for your multi monitor setup? If not, please reply back with the command output of the following command:

hyprctl monitors

Hello, no, I can make it go to 720p and that's the most of it,

My hyprctl monitors output https://pastebin.com/LZcvfbJQ

JesseKoldewijn commented 1 year ago

Check! For me funny enough was the whole "getting multi-monitors to work" not really an issue. Just run into an issue where I basically can't run one of my monitors above 120hz (the monitor itself is a 144hz panel and also shows up as such in the hyprctl monitors output). But apart from that, good setup. Although I do prefer the wallpapers on v2 which are luckily included as well but just not set as default.

I also ran into an issue where the theme switch didn't work on first hyprland run (only started working after the first reboot) but to be honest. Not really to big of an issue imo