SV08 is a flying gantry Core-XY printer with a print area of 350x350x345mm, also a derivative work based on Voron V2.4. It aims to provide an alternative solution for 3D printing enthusiasts who are eager to use Voron V2.4 but are hindered by high costs and learning barriers. SV08 open source (including structure, hardware, and firmware) for users
I have checked the data in the wifi cfg but it wont connect.
I update the printer to firmware version 2.3.3 using another usb but the issue is still there.
I have also created the wifi.cfg on a third usb stick and that did also not work. the ip stays on the default ip (127... not connected)
wifi.cfg:
ssid=Zyxel_1F1F
password=PASSWORDHERE
note: PASSWORDHERE is replaced with the correct passsword.
I am using the 2.4 gh
I have had the file on the usb stick i use to print the hole time i have used the printer and the info is correct but it does not connect. I run a angryipscanner check every now and then. But the printer never shows up and show ip is always the default ip.
I have checked the data in the wifi cfg but it wont connect.
I update the printer to firmware version 2.3.3 using another usb but the issue is still there.
I have also created the wifi.cfg on a third usb stick and that did also not work. the ip stays on the default ip (127... not connected)
wifi.cfg:
note: PASSWORDHERE is replaced with the correct passsword.
I am using the 2.4 gh
I have had the file on the usb stick i use to print the hole time i have used the printer and the info is correct but it does not connect. I run a angryipscanner check every now and then. But the printer never shows up and show ip is always the default ip.