I had my machIne setup for testing while I finished building the table it would be going on. I Was able to control the spindle with the g code sender. After moving it onto the table and resetting up when I send a g code m3 s22000 it turns for a split second and I get a alarm. Spindle speed error rpm not match rpm -1 vs 22000rpm. Is this just interference ? Use better wires?
I had my machIne setup for testing while I finished building the table it would be going on. I Was able to control the spindle with the g code sender. After moving it onto the table and resetting up when I send a g code m3 s22000 it turns for a split second and I get a alarm. Spindle speed error rpm not match rpm -1 vs 22000rpm. Is this just interference ? Use better wires?