As per title; the 0-10V signal is never 0.
I resolved this by using the relay to enable (M3 Sxxxx) or disable (M5).
However, when issuing an M3 S0 the spindle should actually stop, but it doesnt, as theres still 0.5V remaining. And the relay doesnt shut goes to disable state.
SpindleType=PWM
Spindle used: Kress AMB 1400 FME-P DI digital spindle with a 0-10V steering.
If i tune the voltage to below 0.5V with the tuning screw, the 10V is never reached, so this is not workable.
As per title; the 0-10V signal is never 0. I resolved this by using the relay to enable (M3 Sxxxx) or disable (M5). However, when issuing an M3 S0 the spindle should actually stop, but it doesnt, as theres still 0.5V remaining. And the relay doesnt shut goes to disable state.
SpindleType=PWM Spindle used: Kress AMB 1400 FME-P DI digital spindle with a 0-10V steering.
If i tune the voltage to below 0.5V with the tuning screw, the 10V is never reached, so this is not workable.