Open markcagatandavis opened 1 year ago
I'm assuming you're using the command line in CNCjs while connected via USB?
It's likely your router has dynamically assigned a static IP address (e.g. 192.168.0...)
To find out if the xPro is connected to your network as well as obtain the valid IP address (webui address you'll type into your browser) please use the $I
command
$I
This will list the basic connection information$System/Stats
This list Wifi stuff as well as a lot of system information$WiFi/ListAPs
This list all of the Wifi access points found and the signal strengthFyi: steps required to put it on your network if it's not connected...
$Sta/SSID=YourSSID $Sta/Password=YourPassword $Radio/Mode=STA
This is now my THIRD UNIT! and I can't connect to the WiFi with this... no matter if I am using command line or UI.