Open hks211 opened 3 months ago
Dear Huang Kesheng,
when exporting the 3D distribution of scatterers from POV-Ray coordinates (-> context: POV-Ray model) into the world coordinates of the original (-> context: CAD-type model) model you need to compensate for the rotations and shifts you applied in the POV-Ray editor in the context of the #include command. I’d assume that this yields the mis-match.
Regards Stefan Auer
Von: HuangKesheng @.> Gesendet: Donnerstag, 28. März 2024 14:27 An: StefanJAuer/RaySAR @.> Cc: Subscribed @.***> Betreff: [StefanJAuer/RaySAR] how to set up parameters to correct these scatterer signals to match them to the correct position with the 3D model (Issue #15)
Dear Professor, image.png (view on web)https://github.com/StefanJAuer/RaySAR/assets/144893250/9f5ef85d-1ea8-4bf5-b809-973458b0934c image.png (view on web)https://github.com/StefanJAuer/RaySAR/assets/144893250/f6653b86-0629-4027-81b1-01ad73bb010f image.png (view on web)https://github.com/StefanJAuer/RaySAR/assets/144893250/d6b77789-2d6b-48f9-966d-d5bfb9a7d72a image.png (view on web)https://github.com/StefanJAuer/RaySAR/assets/144893250/5a0d413c-1051-4c24-a33f-9b2f3a112c72
I used the simulation tools for exporting the 3D distribution of scatterers. However, it was not possible to match the scatterer signals to the AccuTrans 3D model, and their positions were greatly offset.I don't know how to set up parameters to correct these scatterer signals to match them to the correct position with the 3D model.Could you give me some advice?
Thanks and Regards HuangKesheng
— Reply to this email directly, view it on GitHubhttps://github.com/StefanJAuer/RaySAR/issues/15, or unsubscribehttps://github.com/notifications/unsubscribe-auth/AD4U5T6F544EXXYR7IAQP3LY2QLDRAVCNFSM6AAAAABFMZHGNSVHI2DSMVQWIX3LMV43ASLTON2WKOZSGIYTGMRUGQ4TMMI. You are receiving this because you are subscribed to this thread.Message ID: @.***>
Dear Professor,
![image](https://github.com/StefanJAuer/RaySAR/assets/144893250/5a0d413c-1051-4c24-a33f-9b2f3a112c72)
I used the simulation tools for exporting the 3D distribution of scatterers. However, it was not possible to match the scatterer signals to the AccuTrans 3D model, and their positions were greatly offset.I don't know how to set up parameters to correct these scatterer signals to match them to the correct position with the 3D model.Could you give me some advice?
Thanks and Regards HuangKesheng