Open eadmaster opened 3 years ago
I don't have that one and no one has reported about it, so I can't say for sure, but if it uses the neGcon protocol, it should work.
Interesting question about 3.3V boards. I think they will work but you might need a strong external pull-up (1k) on the DAT line.
ok, i will give a try when i have some free time and all the components required and report back here.
forgot to ask: do you have some time-sensitive code in the lib that won’t work correctly @ 8MHz?
I don't think so but I have never tested the lib at 8 MHz. I'd suggest using the hardware SPI pins for improved reliability.
Any news about this?
still haven't received all the needed parts, i suggest to leave this issue opened until it is verified.
Ok, no problem! Just make sure to report back :).
UPDATE: just built the adapter with a diymore Arduino USB @ 3.3V: tested with a DS2 controller first and it IS working fine!
Btw it is NOT working with the Namco Volume Controller, anything i could try?
Enable debug and report what you get.
EDIT2: after a few tries, with the Volume Controller now i get this in the serial monitor:
Ready!
Controller found!
Cannot enter config mode
Controller lost :(
Controller found!
Cannot enter config mode
Controller lost :(
Controller found!
Cannot enter config mode
Controller lost :(
Controller found!
Cannot enter config mode
Controller lost :(
(loops)
Another try after re-checking the wires, now it stops here:
Ready!
Controller found!
Cannot enter config mode
Try to uncomment the DUMP_COMMS #define in PsxNewLib.h, I need more info.
there you go: log1.txt
(If it does not make any sense i may still have some loose wire on my prototype build i need to fix again)
It doesn't make much sense, but I cannot make a useful analysis if I cannot trust the data you provide. Please make sure your wiring is solid and that you have 1k pull-ups on all lines, then produce a log and I will analyze that.
Just got a Volume Controller and I can confirm that it uses the same protocol as the neGcon and is supported by PsxNewLib. No idea about a 3.3v arduino as I'm using a Leonardo with voltage regulator and level shift for 3.3v.
Hello, I am using this library in an atmega8 at 8mhz, everything works, but there is a problem, it seems that it takes time to read the values of the control, something like a delay, I press, and release the control and in the code it takes a few seconds to detect that I release or press, what can I change to improve the speed? I even removed the delay from the loop of the program, but it's still the same bad.
is it supported?
white Jap version green Eur version (i have one of these)
Reportedly it is using the Negcon analog protocol.
side question: will this sketch also work with an 3.3V Pro Micro board (instead of using a level shifter)?