Open jayanewbie opened 2 years ago
I have this problem too, you managed to solve?
In my case it was a problem with the hardward pin d13 that was poorly soldered and with bad contact,
I have this same issue. Z is turning clockwise but not anticlockwise
I haven't got time to look into this right now but be aware that D13 has an on-board Arduino LED attached to it. My first instinct would be to add a 2.2K-ohm from D13 to 5V to ensure proper pull-up.
My problem was resolved already. It happened because some connections were not firm
Please help me Step Z VIBRATING Step Y Normal Step X Normal I'am Using Arduino Uno give me new schematic for arduino uno Step z partπππ