Filament printer rack tasks

[Mazcuu]

To Do:

• [ ] - Move the upper shelf slightly down to make room so that the BambuLab printer fits below the filament spools. The filament spools shouldn't be raised from where they are so that everyone can reach them.
• [ ] - BambuLabs poop box should be rethought. Maybe we could make a hole in the shelf, and have a tube go all the way down to the bottom of the whole rack?
• [ ] - BambuLabs bowden tube should be extended so that the filament spools above it can be routed to it.
• [x] - Contact @rowan8k to transfer the printer to another BambuLab account. EDIT: No need. We'll not make bambu lab account, as the printer can be used just fine without it.
• [x] - Do a test print. Preferably something that you actually need.
• [ ] - Go through all the other things in the rack. Get rid of what we have no use for.
• [ ] - There are some 3d-pens still around, test them and try to sort out some working ones.
• [ ] - Prusa should be moved on the lower shelf.
• [ ] - We put the Prusa back together after a cleanup and hot end swap. During the first layer calibration there were some problems. I couldnt find a Z offset that would work, so that needs to be looked at.

If you want help and company with this project, you can ask @Mazcuu

[314Sami]

AFAIK, there is/was rolls of 3 mm filament that is probably for historical reasons (see ultimaker in the top shelf) or for 3D pens that there are a lot of (those all need to be looked at, there is a possibility to get few working out of that pile?).