search

TauLabs / TauLabs

taulabs.org
Other
455 stars 393 forks source link

S.Port Telemetry not working correctly with OpenTX 2.1 #1812

Closed WZ9V closed 9 years ago

WZ9V commented 9 years ago

The current S.Port implementation is causing duplicate entries to be created on the Taranis during discovery when using OpenTX 2.1.1 causing all telemetry slots to fill and triggering a recurring error. My understanding is that the Teensy Mavlink converter project has similar issues with OpenTX 2.1.1

Using Taulabs - https://github.com/TauLabs/TauLabs/releases/tag/20150713 on a Sparky with X8R S.Port Telemetry connected to main port. Sparky is only telemetry device but has an AttoPilot connected to ADC 0/1 for voltage and current measurement.

mlyle commented 9 years ago

@WZ9V: Can you please try current next? @xdandys submitted #1731 a few weeks ago for this issue.

WZ9V commented 9 years ago

Where would I get that one from? I'm still pretty new to TauLabs.

mlyle commented 9 years ago

If you need Windows, windows builds were broken for awhile but are now available from: http://jenkins.taulabs.org/artifacts/

Note that the next branch is bleeding-edge and may have critical bugs. It's development in preparation for the next release.

WZ9V commented 9 years ago

I downloaded the 8/19 Windows one from Jenkins and it did indeed fix the S.Port telemetry problem with Open TX 2.1.1 but it was a real pain getting a stable radio calibration and vehicle setup gave me manual, stabilized1 and stabilized1 for my three flight modes. I'll start over again tomorrow and see if it acts weird again but I can at least confirm that the telemetry worked properly. Thanks.

Hope the input helps.

mlyle commented 9 years ago

OK. Vehicle setup doesn't setup flight modes. I will close this issue as it appears PR #1731 is indeed good. Thanks for trying it out!