search

Tencao / TCR-Origins

Issue tracker for the modpack
1 stars 0 forks source link

Energy bridge is not coverting power #46

Closed doctorbmw closed 6 years ago

doctorbmw commented 6 years ago

the rf consumer will show that it is using/storing power but the bridge doesn't seem to convert/transfer to the LV eu producer and tried with a rf producer also

Bluexin commented 6 years ago

Mine are working, both as producing eu and mj. My eu one is MV though I think. Did you actually check it was outputting energy? I don't think it's storing energy on it's own (the producer).

Tencao commented 6 years ago

I'll test this later, however I have seen it working in blues base which makes me think it's a setup issue and not a bug

doctorbmw commented 6 years ago

So is the any configuration to it other than place and go? I have a red consumer feed by IE power. The the bridge right under the consumer. Then the eu producer under the bridge. I used both my and lv ones and connected to a cesu and a mfe and to the energy acceptor for ae2. Nothing is powering. When I hover over the rf consumer it shows a full bar of power 2.1k grf I think

Bluexin commented 6 years ago

to the energy acceptor Setup is:

original power -> consumer -> bridge -> producer -> target power

ie for rf -> mj it could be :
energy cube with output to consumer -> rf/fe consumer -> bridge -> mj producer -> quarry

rf -> eu could be :
energy cube with output to consumer -> rf/fe consumer -> bridge -> mv producer -> mfsu

Pay attention to the input/output sides of ic2's mfe & co maybe ? Send screenshot of your setup, could help too. Ask genetyx or Rastos when they're online to see ours (or if you know our coords, just tp there).

doctorbmw commented 6 years ago

http://prntscr.com/hdm3r1

doctorbmw commented 6 years ago

http://prntscr.com/hdm3yj

doctorbmw commented 6 years ago

http://prntscr.com/hdm42i

Tencao commented 6 years ago

You was using the wrong consumer. IE requires FE Consumer, not RF Consumer