Due to the form factor of the COTS breakout for the Si4463 that was ordered, an additional PCB will be required to connect the breakout to a Teensy and antenna. This board should provide connections from the all available pins on the breakout to the corresponding Teensy pins, and contain a 50 ohm impedance matched trace to connect to a side mounted SMA. Ideally this board will also be able to fit in an L1 for testing, so its shortest dimension should be <2.5 inches, including the antenna.
This issue is high priority since the boards need to arrive, be soldered, and get tested before the October launch.
Due to the form factor of the COTS breakout for the Si4463 that was ordered, an additional PCB will be required to connect the breakout to a Teensy and antenna. This board should provide connections from the all available pins on the breakout to the corresponding Teensy pins, and contain a 50 ohm impedance matched trace to connect to a side mounted SMA. Ideally this board will also be able to fit in an L1 for testing, so its shortest dimension should be <2.5 inches, including the antenna.
This issue is high priority since the boards need to arrive, be soldered, and get tested before the October launch.