search

Thanh19993 / megapirateng

Automatically exported from code.google.com/p/megapirateng
1 stars 0 forks source link

2.9R6 Arming problem with 3DR radio #40

Open GoogleCodeExporter opened 8 years ago

GoogleCodeExporter commented 8 years ago 
What steps will reproduce the problem?
1.start up Crius AIO v1 with 3DR radio on serial3 and CRIUSGPS on serial2
2.start the MissionPlanner 1.2.36 and succesfully start the MAVlink
3.trying to arm/disarm with radio or MissioPlanner buttons

What is the expected output? What do you see instead?
I'm expected to arm/disarm the quad, but the CriusAIOv1 leds stop blinking, 
they go off, and I need to unplug the battery to restart everything.

What version of the MegaPirateNG are you using?
2.9 R6

Please provide any additional information below.
If I remove the 3DR radio and connect the MAVlink with the USB cable everything 
works fine.
The 3DR module is from RcTimer.com, firmware version "SiK 1.6 on HM-TRP", (baud 
57600)

Original issue reported on code.google.com by alberto....@gmail.com on 17 Mar 2013 at 9:55

GoogleCodeExporter commented 8 years ago 
I've tried to downgrade to 2.7R4 and the issue disapeared!

Original comment by alberto....@gmail.com on 21 Mar 2013 at 8:43

GoogleCodeExporter commented 8 years ago 
same problem with 2.8r3. (power on -> reset eeprom -> setup radio/accell 
through USB -> get a valid mavLink connection through 3DR -> real time data 
visualization succefully -> try to arm the quad -> software crash -> status 
leds off -> I can't do anything, only remove the battery)

I can notice that the mavLink connection stop sending a lot of data, and It 
seems sending just periodically heartbeats.

Original comment by alberto....@gmail.com on 25 Mar 2013 at 8:40

GoogleCodeExporter commented 8 years ago 
Solved, 
3DR module made a lot of noise on the power line, adding an aux power source 
solved the problem.
Seems that I2C line was disturbed by such noise.

Original comment by alberto....@gmail.com on 1 Apr 2013 at 4:46