Neptune 3 Pro issue with auto bedleveling calibration

[mastertape]

I have a similar problem with the Neptune 3 pro... like the other issue reported with the 3 Plus

interestingly, the cfg file worked immediately on the sonic pad... when i used kiauh on the raspi 3 klipper, i observed the same phenomenon. However, with my 3 Pro it is the left and upper area that is left out in the auto leveling process.

Incidentally, I have adopted changes to the config file I use on the sonic pad (of course taking into account device-specific changes such as gcode opath directory serial port etc.)...

I assume that the cfg file is correct in terms of the configuration and values. where else could the problem be? where is the bed size asked at klipper? If you added a new printer to the sonic pad, the print bed size had to be specified once.... perhaps the solution lies in entering these values... which additional config file could this affect?

also my printer.cfg is attached running_printer_cfg.txt

and here also a video https://youtu.be/EjhTHppsVH0

[iHunterX]

I second it, I have the same issue, the first layer always seem too high

[TheFeralEngineer]

When setting z offset, do you command probe_calibrate or just try and set it from the axis controls?

On Mon, May 22, 2023, 3:17 PM iHunterX @.***> wrote:

I second it, I have the same issue, the first layer always seem too high

— Reply to this email directly, view it on GitHub https://github.com/TheFeralEngineer/Klipper-for-Elegoo-Neptune-series-3D-Printers/issues/12#issuecomment-1557792928, or unsubscribe https://github.com/notifications/unsubscribe-auth/ARUZ2LORIAAMMRJSO3IAI4TXHO3VJANCNFSM6AAAAAAXBBSU24 . You are receiving this because you are subscribed to this thread.Message ID: <TheFeralEngineer/Klipper-for-Elegoo-Neptune-series-3D-Printers/issues/12/1557792928 @github.com>