Error Codes: key75 - Githubissues

TheFeralEngineer / Klipper-for-Elegoo-Neptune-series-3D-Printers

run Klipper on your neptune 2, 2s, 3, 3pro, etc!

172 stars 28 forks source link

Error Codes: key75 #13

Open viruz82 opened 1 year ago

viruz82 commented 1 year ago

Hi and thank you for your files,

I have a Neptune 3 Pro and after setting up fans, auto leveling and so on I get the following error: Unable to infer homing_positive_dir in section 'stepper_z' Once the underlying issue is corrected, use the "RESTART" command to reload the config and restart the host software. Printer is halted Any ideas?

Thanks and regards Kai

TheFeralEngineer commented 1 year ago

sorry, just seeing this. Please upload your printer.cfg if you haven't resolved this issue yet.