search

Threadfin / Threadfin

an M3U proxy for Kernel/Plex/Jellyfin/Emby based on xTeVe
MIT License
777 stars 56 forks source link

Upgrading from Version 1.0(16) -> Version 1.1(13) - Plex Playback Error Could not tune channel. Please check your tuner or antenna. #272

Closed mkanet closed 5 months ago

mkanet commented 5 months ago

Please first read the documentation. Problems affecting the client, e.g. Plex or Emby should be reported there in the forum.

Describe the bug When I try to play any LiveTV shows in Plex after upgrading from Version 1.0(16) -> Version 1.1(13), none of the LiveTV channels will stream to Plex. I get the general error: Playback Error Could not tune channel. Please check your tuner or antenna.. If I revert back to the old version of Threadfin, all LiveTV channels start working again. There are no warnings or errors in the Threadfin log. In Plex's console, the only related error was:

[HttpClient/HCl#75dc] HTTP error requesting GET http://192.168.1.2:34400/discover.json (7, Couldn't connect to server) (Failed to connect to 192.168.1.2 port 34400 after 2021 ms: Couldn't connect to server)

NOTE: I changed the bind IP address from 0.0.0.0 to 192.168.1.2, however, that didn't make any difference to the above issue. The only easy fix I know is to revert back to Version 1.1(13).

Server (please complete the following information):

To Reproduce Steps to reproduce the behavior:

  1. Play any LiveTV channel in Plex

Expected behavior The playback to start normally just like the older versions of Threadfin

Screenshots If applicable, add screenshots to help explain your problem.

Desktop (please complete the following information):

Additional context Add any other context about the problem here.

Fyb3roptik commented 5 months ago

Did you enable ssdp?

Fyb3roptik commented 5 months ago

Check settings and make sure ssdp is enabled

mkanet commented 5 months ago

@Fyb3roptik I just checked. SSDP is already enabled.

Is there any information I can provide you to help you know what might be wrong? I've been using the same settings/configuration for many years, even when I was using xTeVe.

2fst4u commented 2 months ago

Same issue here. SSDP is enabled. Closing this as complete is a bit rude.

mkanet commented 2 months ago

@2fst4u I agree. I decided to continue remaining on the older version 1.0 Build: 16 indefinitely since I'm not sure how what to do to avoid this.

Also, versions newer than 1.0 Build: 16 also have UI sluggishness that didnt exist before.