search

TinkerGnome / Ultimaker2Marlin

105 stars 38 forks source link

17.02.1 Dual It does not work on UltiGсode #64

Open qwerty8224 opened 7 years ago

qwerty8224 commented 7 years ago

Tinker-MarlinUltimaker2-dual-17.02.1.hex Tinker-MarlinUltimaker2plus-dual-17.02.1.hex

UltiGcode work Tinker-MarlinUltimaker2plus-17.02.1.hex

gr5 commented 7 years ago

Can you please provide more information. What doesn't work? And please don't create many issues all about the same problem.

qwerty8224 commented 7 years ago

firmware dual extrusion no work UltiGcode firmware dual extrusion working Reprap/marlin firmware one extrusion working Reprap/marlin UltiGcode

gr5 commented 7 years ago

What do you mean "no work". Does the printer boot up? Do the menus work? Do you print usb or SD card? Does it work for a few minutes? Does it crash? Does the bed heat up? Does the screen not even come on? Does it show version upon boot?

What do you mean "no work"

qwerty8224 commented 7 years ago

SD card. Warm Bed nozzle but printing does not start

gr5 commented 7 years ago

This is useful. Is the display locked up? Or can you go into tune and abort the print? Can you post the gcodes here from your SD card up to and including the first movement (first G0 or G1 command) please?

qwerty8224 commented 7 years ago

I can cancel printing works display. Gсode can lay out tomorrow .... printer at work

qwerty8224 commented 7 years ago

;FLAVOR:UltiGCode ;TIME:704 ;MATERIAL:1028 ;MATERIAL2:0

;Layer count: 71 ;LAYER:0 M107 G0 F12000 X93.028 Y93.028 Z0.260 ;TYPE:SKIRT G1 F1800 X93.881 Y92.329 E0.11469 G1 X94.849 Y91.812 E0.22882 G1 X95.901 Y91.492 E0.34318 G1 X96.820 Y91.400 E0.43924 G1 X113.180 Y91.400 E2.14068 G1 X114.099 Y91.492 E2.23673 G1 X115.151 Y91.812 E2.35109 G1 X116.119 Y92.329 E2.46522 G1 X116.972 Y93.028 E2.57991 G1 X117.671 Y93.881 E2.69460 G1 X118.188 Y94.849 E2.80873 G1 X118.508 Y95.901 E2.92309 G1 X118.600 Y96.820 E3.01915 G1 X118.600 Y113.180 E4.72059 G1 X118.508 Y114.099 E4.81664

gr5 commented 7 years ago

Good info. So it warms the bed. Warms the nozzle. And then just gets stuck - it never does even the first G1. But you can go in and choose "abort".

qwerty8224 commented 7 years ago

Yes

Aleksys007 commented 7 years ago

I confirm, the printing does not even begin. 100% appears on the screen and nothing happens.

qwerty8224 commented 7 years ago

This occurs when passing from RepRap to UltiGcode 2