This applies when using a light with aux LEDs such as the ts10 or ts10-rgb.
Steps to reproduce:
after factory reset, enter advanced mode. On ts10, smooth ramp floor level will be 1/150.
using 9H from on, activate an aux LED as a channel.
Using 3C from on, select the now active aux as the active channel.
Select the floor level. The aux LEDs will be off.
My expectation is that when using an aux LED as an active channel, the light being on at level 1 should result in the aux LEDs being active, but this doesn't seem to be the case. When ramping to any other level (2+), the aux LEDs are on at the high level.
This applies when using a light with aux LEDs such as the ts10 or ts10-rgb.
Steps to reproduce:
My expectation is that when using an aux LED as an active channel, the light being on at level 1 should result in the aux LEDs being active, but this doesn't seem to be the case. When ramping to any other level (2+), the aux LEDs are on at the high level.