search

TriForceX / MiyooCFW

Custom firmware source code and resources for BittBoy, PocketGo, PowKiddy V90-Q90-Q20 and third party handheld consoles
GNU General Public License v2.0
1.1k stars 110 forks source link

Brick the firmware #80

Closed ing-fcastellanos closed 4 years ago

ing-fcastellanos commented 4 years ago

Hi, the cfw works great, but I have notice that when I enter: select + TA at the main menu, the screen goes black, after that the cfw doesn't respond. The worst is that after I switch off and on, the "unclear shutdown" message appears, the bittboy splash screen and then noting, a black screen and the cfw just don’t boot. I am using the bittboy V3.5 and the cfw V1.3.1 Thanks!!

Valnjes commented 4 years ago

I have the same issue. Plus the PocketGO vibrates every few minutes. Im flashing the 1.32 and hope it works again.

Valnjes commented 4 years ago

1.32 Fixed the issue on my PocketGO.

TriForceX commented 4 years ago

The firmware doesnt get bricked... is just the brightness that is goes set to 0, the volume & brightness key combos changed on the lastest firmware, so is recommended to use the R + DPAD (see wiki here for all combinations)

Of course you get an "unclean shutdown" because you turned off the console from power switch... if goes black just use again SELECT + TB or R+RIGHT

homeswitcher commented 2 years ago

OMG THANKS SO MUCH MY BRIGHTNESS WAS 0 I WAS ABOUT TO HAVE A MENTAL BREAKDOWN