Review enclosure design

Tympan / Tympan_Rev_F_Hardware

Tympan Rev F Hardware Design Files

CERN Open Hardware Licence Version 2 - Permissive

4 stars 0 forks source link

Review enclosure design #9

Closed eyuan-creare closed 2 months ago

eyuan-creare commented 2 months ago

Noticed a couple of issues with the new enclosure (recvd Sept 24, 2024).

[x] Heat sink insert needs thicker boss
[ ] ~Square light pipe hard to press in (but goes in well after initial push)~ Design matches specs. Leave as-is for now.
[x] Upload revised design and STEP, STLs.

eyuan-creare commented 2 months ago

Fixed the missing boss reinforcement. I didn't mirror the feature.

eyuan-creare commented 2 months ago

Charging LED: BIVAR PLPQ2-188-FF

Requires panel cutout of 0.080in sq with 0.008in radius.

This matches the existing design:

Leave as-is for now and see if it is an issue with future prints.

biomurph commented 2 months ago

@eyuan-creare I have not been using a square light pipe in that position. The charge LED shines through quite well as it is.

You mention the heat-sink insert, the blue in your rendering is on the screw side of the join, not the thread side?

eyuan-creare commented 2 months ago

Yes, my mistake. The clearance for the screwdriver has a thin wall that blew through. I've added thickness there. I will correct the typo in the issue. Light pipe won't be present for typical production units, correct.

eyuan-creare commented 2 months ago

Uploaded new STL's (units: mm), STEP, and PDF of assembly drawing. Pushed new files to branch and merged with trunk.