It seems that all PI hats w/ fans while using heat sinks are just a bit to high to fit into the opening for each "tray". I was able to mod the case using and this UCT PoE Hat u6110.
I had to make two modes (see attached pictures)
cut away a little of the top lip of the rack bay (will make it better, the image below is just to see if it fit)
add pin extension headers then cut them away after the PoE hat
It would be nice to make the bay entry big enough to support other PoE hats and fans.
It seems that all PI hats w/ fans while using heat sinks are just a bit to high to fit into the opening for each "tray". I was able to mod the case using and this UCT PoE Hat u6110.
I had to make two modes (see attached pictures)
It would be nice to make the bay entry big enough to support other PoE hats and fans.
Pic 1 - Rack
Pic 2 - PoE Hat w/ pin cuts
Pic 3 - Heat Sinks