search

USST-RADSAT-SK / software-and-command

Code and Documentation for USST’s RADSAT-SK in their first Canadian CubeSat Project
8 stars 0 forks source link

Admin/adding jlink launcher #167

Closed ChrisAmaya closed 2 years ago

ChrisAmaya commented 2 years ago

I copied the launch file from the getting_to_start project on Dropbox to our project and followed the steps mentioned in "Getting Started" pdf.

How to confirm that this launch file is working:

  1. Gain remote Access (DM me on Slack for step by step)
  2. Select "Jlink-samg20-GDB.launch" in project
  3. Click on the arrow down on the External tools button (Green play button with brown suitcase Icone)
  4. Run as -> then click "Jlink-samg20-GDB.launch
  5. Select "radsat-sk-debug.launch"
  6. Click on arrow down on Debug button (green beetle)
  7. Debug as -> click "radsat-sk-debug.launch"
  8. There is a prompt for that there is an error but select yes to launch for now
  9. At the top right of the screen there should be a debug window. Click the first green play button and notice that there are address ing bring written to
  10. drop down "radsat-sk-debug [GDB Hardware Debugging]
  11. and click on "arm-non-eabi-gdb" and notice there are messages prompting

I am not sure this is a correct configuration because if you click on the Hardware debugger there is no console output