PCB does not fit into the case

[kristjanp28]

Here are the problems regarding the PCB fitment into it's designated case. Issues go as follows:

• hole for the auxiliary connector is to low and makes PCB spring back.
  1. Redesign the case and put the cutout higher
  2. If aveliable make standoffs shorter by 1 mm
  3. leave as is
• PCB holes are to high and you cannot screw it in. PCB needs to sit lower.
  1. redesign PCB and place connector higher (that would lower the PCB and fix the issue), holes on PCB need to be bigger (3.5 mm).

[kristjanp28]

PCB springing back