hiskynet commented 2 years ago

Application Version

4.13.1

Platform

Windows 11

Printer

Geeetech A10M

Reproduction steps

give slice command sometimes can't slice and giving bug error [3dtouch installed]

Actual results

and if tried to print just ran into regtingles around the plat (Z 500) and extrude even temp is low

Expected results

1- to print normally 2- Dual extruder and color mixing plugin not working on Cura

Checklist of files to include

[ ] Log file
[ ] Project file

Additional information & file uploads

I'm not pro, but learning

Updated to Marlin 2+

tweaked the configuration.h file, auto bed leveling is working, and calibrated and tested on Marlin 1.1.8. but this bug showed, and can't print anymore after updated.

Uncommented

define USE_XMAX_PLUG //Check

define USE_YMAX_PLUG

define NOZZLE_TO_PROBE_OFFSET { -37, 0, -2.4 }

define Z_SAFE_HOMING //3Dtouch

fvrmr commented 2 years ago

Hi @hiskynet thank you for your report. Could you share a project file (file - save project) that doesn't slice here in a .zip file?

hiskynet commented 2 years ago

Thanks a lot for your kind response

I think Cura plugin problem (I guess "universal settings"" plugin)

Best Regards DrMu

On Fri, Apr 8, 2022 at 7:53 PM Fenne @.***> wrote:

Hi @hiskynet https://github.com/hiskynet thank you for your report. Could you share a project file (file - save project) that doesn't slice here in a .zip file?

— Reply to this email directly, view it on GitHub https://github.com/Ultimaker/Cura/issues/11770#issuecomment-1092781542, or unsubscribe https://github.com/notifications/unsubscribe-auth/AHA67KFTUD7CZSOSJ7OMWHLVEAM27ANCNFSM5SS4B3TA . You are receiving this because you were mentioned.Message ID: @.***>

Ultimaker / Cura

sometimes can't slice giving bug error #11770