search

Ultimaker / Cura

3D printer / slicing GUI built on top of the Uranium framework
GNU Lesser General Public License v3.0
6.18k stars 2.08k forks source link

suppor #16793

Open j8417817 opened 1 year ago

j8417817 commented 1 year ago

Cura Version

5.4.0

Operating System

windows 11

Printer

creality cr6-se

Reproduction steps

i think there is an issue with the support interface horizontal expansion. i don't get the issue in 5.2.1 but i do in 5.4.0

screenshots attached x 2

Actual results

support interface hangs over the model sides and is surrounded by extra lines, i have selected to remove these lines, which does remove them but replaces them with the support pattern.

Expected results

i expect to see the result as shown in 5.2.1 where the support interface is only within the area of the model. in 5.2.1 when 'support interface horizontal expansion' is ticked to be added to the drop down list, nothing is added. maybe this is where the glitch is happening with 5.4.0? as it does add this option to the drop down menu.

Add your .zip and screenshots here ⬇️

5 4 0 5 2 1 CCR6SE_gps1.zip 5.2.1.zip 5.4.0.zip t roof bug in 5.4.0

GregValiant commented 1 year ago

Thanks for the report. I can duplicate the problem and the Cura team will take a look. It appears that this might not be all about Support Horizontal Expansion and Support Interface Horizontal Expansion. If I set the Support HE to a number between 0 and "1 line width" the Interface expands off the part. If I keep making the Support HE larger the Interface stops expanding and gets "framed" with a wall which wasn't enabled.

The Cura team will take a look.