Tried to slice and print only using right extruder (#2). The software does not seem to recognize the #2 extruder in this mode. Further the filament diameter is set to 2.85 vs the 1.75 that it should be. When attempting to print, the printer uses #1 extruder. The Sovol Cura software accurately recognizes the #2 extruder.
Actual results
Uses wrong extruder
Expected results
There is no option to select the right (#2) extruder ... it simply gives an option to select an extruder and keeps the default #1 extruder.
I think I resolved this by adding T1 to the beginning of my start GCODE. I don't believe there was anything to tell it to use any extruder than the one it was last set to.
Cura Version
5.6
Operating System
Window 10
Printer
Sovol SV04
Reproduction steps
Tried to slice and print only using right extruder (#2). The software does not seem to recognize the #2 extruder in this mode. Further the filament diameter is set to 2.85 vs the 1.75 that it should be. When attempting to print, the printer uses #1 extruder. The Sovol Cura software accurately recognizes the #2 extruder.
Actual results
Uses wrong extruder
Expected results
There is no option to select the right (#2) extruder ... it simply gives an option to select an extruder and keeps the default #1 extruder.
Add your .zip and screenshots here ⬇️
SSSM02_Handles.zip