Open WernerHerr opened 3 months ago
Thanks for the report. I can't duplicate the problem. The project slices fine for me and I didn't find any errors in the model.
Could you post the "Cura.log" file? You can find it using "Help | Show Configuration Folder". Someone from the Cura team will take a look.
As an aside (and this is purely opinion) - If this is a functional piece (as opposed to a mock-up part) I'd print it like this with extra walls around the counterbored holes and less dense infill but with an infill wall count of 3:
GV_Tumbler Motor Face Bracket v9.zip
Hi Thank you so much for the reply I rolled back to 5.5.0, and it worked fine. There was probably a problem during the install I really appreciate the feedback
Regards Werner
Sent with Proton Mail secure email.
On Tuesday, May 7th, 2024 at 12:42 PM, GregValiant @.***> wrote:
Thanks for the report. I can't duplicate the problem. The project slices fine for me and I didn't find any errors in the model.
Could you post the "Cura.log" file? You can find it using "Help | Show Configuration Folder". Someone from the Cura team will take a look.
As an aside (and this is purely opinion) - If this is a functional piece (as opposed to a mock-up part) I'd print it like this with extra walls around the counterbored holes and less dense infill but with an infill wall count of 3:
GV_Tumbler Motor Face Bracket v9.zip
— Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you authored the thread.Message ID: @.***>
Cura Version
5.7.0
Operating System
Windows 10
Printer
Prusa I3
Name abnormal settings
None
Describe model location
Slightly forward
Describe your model
Bracket
Add your .zip here ⬇️
Tumbler Motor Face Bracket v9.zip