Open redzabu opened 1 month ago
Asterchades
commented
1 month ago Without the affected STL to replicate the issue there isn't going to be a great deal that can be done about this. It could be a corrupted or faulty file, or it could be an edge case which has implications elsewhere but hasn't been nearly as obvious an issue to investigate.
CrashTD
commented
1 month ago Likely dublicate of #18968?
Check if disabling USB Printing fixes the issue. This is of course no permant solution.
redzabu
commented
1 month ago Spot on !
disabled USB printing and ... problem solved
For now i'm happy again - Thanks !
On 28/05/2024 10:10, CrashTD wrote:
Likely dublicate of #18968 https://github.com/Ultimaker/Cura/issues/18968?
Check if disabling USB Printing fixes the issue. This is of course no permant solution.
— Reply to this email directly, view it on GitHub https://github.com/Ultimaker/Cura/issues/19139#issuecomment-2134599322, or unsubscribe https://github.com/notifications/unsubscribe-auth/AI2GHBGPR2FLLBZTK5R4WMLZEQ3XLAVCNFSM6AAAAABIKDFQJKVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDCMZUGU4TSMZSGI. You are receiving this because you authored the thread.Message ID: @.***>
kafufafu
commented
3 weeks ago Could this have had any relation with the following? #19186
Cura Version
5.7.1
Operating System
Fedora40 Wayland
Printer
Creality Ender 3 s1 pro
Reproduction steps
Starting fresh cura appimage - OK - loads in less than 20 sec ... Load a simple testcube .stl file takes more than 90 sec on an AMD7 7 PRO 6850H with Radeon Graphics ?!?! This behaviour is consistent across 3 machines (2 AMD 7 and 1 I5)
Actual results
import of a simple .stl file in a few seonds
Expected results
Import takes AGES!
Add your .zip and screenshots here ⬇️