Closed MrRickie closed 2 months ago
Hey @MrRickie , can you also include a project file? Or at the very least the Cura.log file from the configuration folder. Without these we can't investigate the source of your issue.
Can confirm this is the case for the last few Linux appimage release too.
This file never slices Francis.zip
@gazhay I recommend you look into the user changed settings and configurations you have. The file you included is a STL rather than a 3mf so I have no way of reproducing the issue you're reporting. To break your absolute statement of "This file never slices", here is a sliced version of the STL you included using the 5.8 appImage. I picked a random printer.
@gazhay I recommend you look into the user changed settings and configurations you have. The file you included is a STL rather than a 3mf so I have no way of reproducing the issue you're reporting. To break your absolute statement of "This file never slices", here is a sliced version of the STL you included using the 5.8 appImage. I picked a random printer.
Well previous versions handle the file with those settings, its a thing in recent versions (as in settings & file don't change but behaviour does)
My workflow has always been (6 or 7 years+) openscad->stl->cura->scad->print so i've no idea what 3mf I would need to produce?! Seems like a red herring in this case.
This issue has been automatically closed because there has been no response to our request for more information from the original author. With only the information that is currently in the issue, we don't have enough information to take action. Please reach out if you have or find the answers we need so that we can investigate further.
Cura Version
5.8.0
Operating System
windows 11
Printer
Lotmaxx Shark
Reproduction steps
Loaded stl from drive then started with checking printer and slicer settings all look good then start slicing.
Actual results
Slicer starts slicing then just never finishes. Waited over night and it never went past half way. It just starting doing this was working fine before. Have not changed anything sence last GOOD slice.
Expected results
Slicer should slice the stl file then create a gcode file to save to disk.
Add your .zip and screenshots here ⬇️