search

Ultimaker / Cura

3D printer / slicing GUI built on top of the Uranium framework
GNU Lesser General Public License v3.0
6.17k stars 2.07k forks source link

Missing infill in small parts #19441

Open Schatta123 opened 3 months ago

Schatta123 commented 3 months ago

Cura Version

5.8.0-beta.1

Operating System

Windows 11

Printer

Biqu B1

Reproduction steps

In a object smaller than 3mm Cura 5.8 beta 1 does not put infill like in this picture: Screenshot 2024-07-28 191614 While in cura 5.7 it does put infill. Here is the same example: image

Actual results

When this happen I do not get infill in those parts

Expected results

It should have infill in that part

Add your .zip and screenshots here ⬇️

I have already attached the screenshots

GregValiant commented 3 months ago

Thanks for the report. The brown lines in both images look like Infill. Either the images aren't describing the problem, or I'm just not getting it. Put some arrows on the images to point to where you see a problem. A project file would be helpful. When you choose an infill that "moves" from layer-to-layer (ex: "cubic"), and the part is small, then some areas will appear to be missing infill because it has moved away. If the part was taller you can see it come back. The infill density also plays a part.

Schatta123 commented 3 months ago

Here it is suppose to be infill but cura does not put it (Cura 5.8 Beta 1) Screenshot 2024-07-28 191614 And if I use the same profile but in cura 5.7 all work fine and there it has infill Screenshot 2024-07-28 191945 It only happen when the object length is less than 3mm. Here I made another example in cura 5.8 Beta 1 Screenshot 2024-07-29 001855 As you can see the object is hollow but it should have a 30% cubic infill. So it is not working as it should. For now I will use Cura 5.7 until this bug has been solve. Sorry I do not know how to send a project file. I hope now is more clear. Thank you