Open GamesOnPaper opened 1 week ago
Thanks for the report. I can reproduce this in 5.8.0 and it does look like a bug. To eliminate the problem for this particular project - set the "Support Density" to "0%".
The Cura team will take a look.
Can you elaborate on what setting the support density to 0 will do? That's a setting I typically set to 3 or 4%
Cura Version
5.8.1
Operating System
Windows 10
Printer
Snapmaker J1 IDEX
Reproduction steps
I have a Snapmaker J1 IDEX, I was on an older version and I upgraded to 5.8.1 and there is a bug where the layer in the support between the support and support interface prints the support infill across gaps. This only occurs with tree supports and not with normal supports. If I disable support infill it goes away, but that is not ideal. Attached is 3mf
Actual results
This is what it currently looks like in 5.8.0 and 5.8.1
Expected results
This is what it looked like in 5.7.1
Add your .zip and screenshots here ⬇️
SJ1_Support Test.zip