Not using assigned fixed IP

[fth1963]

Describe the bug I have assigned amsreader to use a specific fixed (/24) IP address, but it uses another.

To Reproduce I'm not sure how to reproduce. I have assigned IP 192.168.1.98/24 to it but after searching I have found out it uses 192.168.1.122. Looking at the settings I can see that it still shows my original setting for a fixed IP 192.168.1.98/24.

Expected behavior I expect it to use the IP address I have assigned in the settings.

Screenshots

Hardware information:

• Country: Denmark
• Meter: AMS Reader v 2.3.1
• Encryption enabled: yes
• AMS reader: Pow K+
• M-bus adapter (if applicable):

Relevant firmware information:

• Version: 2.3.1
• MQTT: yes
• MQTT payload type: Don't know looking directly a web page
• HAN GPIO: [e.g. GPIO5]
• HAN baud and parity: [e.g. 2400 8E1]
• Temperature sensors [e.g. 3xDS18B20]
• ENTSO-E API enabled: [yes/no]
• Chip: esp32s2 (160MHz)

Additional context Add any other context about the problem here.

[fth1963]

After reboot it used the original fixed IP.

[ArnieO]

Strange. Could there be an IP conflict on your gateway, with more than one device requesting to use the same static IP?

[gskjold]

Upgrade your device, this was fixed in 2.3.4