M.Design.Rubber Feet

[VillageHubertChen]

• [x] HC: Develop specs
• [x] ML: Find and order candidate samples of screws and feet
• [x] ML, HC: IQC screws and feet. Make test assemblies. Test according to below specs. Pick a pair.
  • → Found a feet that is sturdy, fit dimensions and does not leave marks on table
  • → Found screw / feet combination does not need washer and holds the feet very tight
• [x] ML: Document in production BOM which one we will be using in production
• [x] ML: Update 3D-Model with final dimensions of Screws and Feet

  Specs

• Feed connects stable to housing. Even when pushing housing across the table the sheet does not sheer off after prolonged stress
• screw is inserted deep enough into rubber feet to not scratch the table surface, even if pressure put to housing
• screw does not leave marks on table surface
• feet is not too high. Preferred height is 5 mm
• feet is not too large diameter, preferred diameter 11 mm. Otherwise too close to edge of Bottom-Cover
• Screw has washer integrated. This speeds up assembly process.
• Screw is black for cosmetic reasons

[VillageHubertChen]

Thank you so much for closing an issue you worked down! Please keep doing this :+1: